Name: user name. The name entered in this section will be used upon selecting the notification channels when configuring events.The Pager4 PRO includes the following extra functions: E-mail notification Push notification TELL Control Center multiplatform mobile application (iOS and Android) IP camera support.
The 3G (UMTS) communication makes possible higher speed, thereby increasing the speed of reporting. The 2G and 3G models can be used in Europe, while the 3GA model is equipped with a pentaband UMTSHSPA modem that can be used worldwide. If a normally open dry contact is used to activate the input, choose the NO (normally open) option at the given inputs settings. The device comes with an antenna which provides good transmission under normal reception circumstances. In case of experiencing signal strength problems orand wave interference (fading), use another (directed) type of antenna or find a more suitable mounting place for the antenna. Install Proseries On Terminal Server Software Can BeThe latest version of the programming software can be downloaded from the manufacturers website ( ). The Pager4 programming software can be used to configure all Pager4 device models. ![]() Configuring directly via USB To start programming the device, follow the instructions below. For this, the APN settings should be configured in the General settings menu and it is also necessary to have installed into the device a SIM card with available mobile Internet service which uses public APN, or, if using a private APN, accessing the cloud server IP address should be enabled in the given APN. If cloud usage is disabled, the device will not keep continuous connection with the cloud server, it will only connect upon request. In case of private APN, for the SIM cards in the given APN, sending and receiving data between each other should be enabled. Also use this connection type if the Pager4 device is connected to a TELLMon receiver and the device is configured to communicate with the TELLMon receiver using the TEX-MVP protocol. Install Proseries On Terminal Server Password Should BeIf you wish to use the admin level access as well, for this the password should be configured separately by clicking on the Change Admin password. Restore factory default settings: By clicking on this button, you can restore the factory default settings in the device. Restoring the factory default settings will erase the actual settings, therefore please save your settings if needed. Changing the device settings: In order to change the device settings, first you have to read the actual settings from the device by clicking on the Read button in any submenu. Write the settings into the device: After changing the settings or entering new settings, in order to take effect, it is necessary to write the new settings into the device by clicking on the Write. For armingdisarming by dry contacts you can use any accessory which has dry contact outputs, e.g. This makes it possible to avoid a faulty detector connected to an input to generate alarms and notifications continuously. The length of the SIA user account ID is 1 to 6 hexadecimal characters, and the following characters can be used: 0.9, A, B, C, D, E, F. The device supports access of up to 4 mobile devices, for which you can configure here the registration password requested upon assigning the mobile application to the device, and it is also possible to delete a mobile device if needed, i.e. Install Proseries On Terminal Server Code Includes ConnectionThe QR code includes connection data: device ID, server IP address and port number, and the sequence number of the mobile device user (1 to 4). The name entered in this section is used for identification of the serverreceiver within the program, and the program will also use this name when configuring notification templates.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |